STL EXPERT 3的安装问题

chenxinwang

昨天我发贴问了老诚一个问题，是想用ug做网格前期处理后导入到MPI，自已试了若次未果，老诚也试过说是V18以上不支持，呵呵就不钻牛角太深了，现在只好退而求其它，想试用STL EXPERT处理，但是我安装的东东有MF6.1 ,cad doctor3,转换器也装好了，能导入导出若种格式的3D文件，唯一不能打开的就是STL EXPERT 3，
提示为：
                        License not Availlable

下面我附上我照做的安装过程，我是亦步亦趋做的啊：
3 W' l( {5 \' D$ U# k# W1. Install "Plastics Insight 6.1", including "Product Security"
2. Optionally install "CAD Doctor 3.0" & "Magics STL Expert 3.0", "Design Link 5.3"
3. Stop "moldflow Product Security" service if it runs.
: P. V8 d; t+ i) v+ P# z3 `* }; v4. Put MF2007_fix.exe to "Program Files\Moldflow\Product Security\" and run it there.
5. Put MF2007_fix.exe to "Program Files\Moldflow\Plastics Insight 6.1\bin" and run it there.
6. If you done #2, run MF2007_fix.exe in:
9 @& I% Z( D! l  D: S "Program Files\Moldflow\CAD Doctor 3.0\bin",
"Program Files\Moldflow\Design Link 5.3\bin",
"Program Files\Moldflow\Design Link 5.3\Backup\pre_5.3000\bin" (depending on updates installed)
7. Put mfpsd.exe & keyfile to "Program Files\Moldflow\Product Security\"
0 D' b, I! x* x6 u8. Start "Moldflow Product Security" service and wait some time (1 min), or reboot
' d6 w, _7 B% o
这应该就是大众破解版的安装过程吧。

有哪位知道怎么解决此问题的请赐都了。
5 R+ h" Q; `6 ^% ?( Z末了，再次向老诚致谢，昨天我发巾后好像就一个小时就看到了老诚的回贴，有如此版主，我等想不进步都难！谢谢

2CHANGCHUN

软件安装后必须先停止MOLDFLOW 的服务，等破解文件安装并覆盖后在启动，还有要检查你的网卡，必须是可以用，否则也是不可以的