ug nx7有限元分析出错求助

ziguixiao

诸位ug大侠：
1 o& s" `/ N9 F5 V0 A7 e
我在做UG nx7的一维，二维单元有限元分析，在解算时出现如下错误：

Mesh-Based Errors Summary
# a) {7 A9 [2 L7 y-------------------------

6 _- |" U1 ^; Q; j+ I$ @. fERROR
There is an update pending.
+ w. t2 }; J5 n" KIf the job is submitted before an update, the results will not reflect the changes made
to the part.
SUGGESTION: Perform an FEM update or use File->Simulation->Export to write out the model
; g2 z8 l3 j! Y0 Sdata without an update.

Total: 1 error and 0 warnings
) @4 X) [: r4 o/ K, v9 c4 g
  U. i) w) x3 r1 \


& N: p/ J# @. M/ m1 d+ _6 X
6 C' s. R: V0 U9 i
( }5 |6 |: M8 kLoad/BC-Based Errors Summary
----------------------------

ERROR
Load "Force(1)" has no underlying mesh that uses the same geometry as the load or the
; k' x9 M+ C: Kunderlying mesh is inconsistent with the load type.
. }1 N4 `6 Y! _7 O+ ?0 ^SUGGESTION: Create a mesh that uses the same geometry as the load or ensure that the
9 l6 }2 v( N4 U% ]: v0 Ounderlying mesh type is consistent with the applied load.
4 {8 H6 A& A& R
Total: 1 error and 0 warnings


* b; f# H( Z1 _! _4 }1 B; `0 ~


0 b! |" J" f$ V$ e( \以致未能成功解算出结果。

请诸位大侠多多指正，还劳请长辈高手们发几个关于ug nx7版本的 一维，二维，三维装配之后整体的有限元分析视频，谢谢。
! K$ S' a2 o" ]; F4 a( }# K( T谢谢高手们，谢谢大侠们，谢谢朋友们。

laoagen

LZ，有无UG NX7.0有限元分析入门实例教程？
' y5 {8 p0 z! F* l& PCAE CAST我已经下载了，是英文，我看不懂，有中文教程吗？

ziguixiao

楼上的兄弟  你在哪下载的   UG NX7.0有限元分析入门实例教程
英文版的也行啊   我还能啃几个英文  谢谢哦‘
给个下载链接吧 谢谢哦 感激ing

work916

我的7NX7.0高级仿真里图标是暗色不可选的   设计仿真里  只能搞到解算这个步骤  没有进入后处理的功能选项   这是怎么回事啊？求高手解答