求助：点在线上副的设置

colin04

要设置某个连杆在一个力作用下沿曲线运动
  [, |/ n. y* v) y! ^0 t给连杆设置了矢量力之后，再用点在线上副约束
' R6 I9 x9 A9 @* p2 v# X点为连杆上的某一点，线为一条直线
* w$ W  L" d2 C: l( K* @& X2 h7 T这样设置之后求解时出现错误提示：

The Initial Conditions displacement solution failed.  ADAMS/Solver could
  _# C- D( L( t not determine the initial assembled position configuration of the model.
+ f$ G: g9 k, o6 r1)Try increasing the number of iterations for convergence.  Current value: 25.
. s9 a/ m" o. Z2)If redundant constraints are present try to eliminate as many as possible.
3)Make sure prescribed motions are consistent with other aspects of the
  t; g% }# i8 E7 v- C  current model position.
4)Check to see if joints are inconsistent (contradictory); eliminate them if so.
$ u. u$ x( N1 {8 r, A9 |- _: z' D. N' J5)Check to see if parts are not too distant from an assembled configuration.

: ~. x* w8 s8 p( _. s$ l# O请问问题出现在哪？

! }/ z5 G; s- p+ Zps：哪位高手有点在线上副的例图，能否分享一下
colin04@126.com
多谢！！！

东莞孙师师

http://v.uggd.com/video.php?t=6这里有视频。

liusaihua123

可以用ug自带的关键帧动画实现

masirlong

还需添加方位运动副、驱动