约束手动耦合后报错，解算时停止，求高人解答

451935318

qiufang840706 发表于 2011-12-23 08:41
在参数列表中有一项“AUTOMPC”，其右选择框中是“NO”设置为“YES”。

一直改   改完还变回去啊  
/ F. m% ?3 p* B9 v+ [0 z# _

- |% a$ ?, _, e8 H, V8 S USER FATAL MESSAGE 2050 (AUTOMPC)
     AUTOMPC PROCESSING ABORTED DUE TO FAILURE TO EXTEND MEMORY SUFFICENTLY
6 C8 _& x6 d) V     TO KEEP THE EXPANDING CONSTRAINT MATRIX IN MEMORY. THIS IS A VERY
$ h7 T# z$ j% U+ W     UNUSUAL OCCURENCE BUT CAN RESULT FROM A LARGE NUMBER OF DOFS BEING
) n% S8 d' L9 i9 p& {2 K# K0 O     DEFINED IN THE U5 SET. INCREASING THE MEMORY ALLOCATION WILL RESULT IN
. E! t+ e7 Q" R8 X# s' G     SUCCESS BUT THE AMOUNT NEEDED MAY BE MORE THAN IS FEASIBLE.
*** USER INFORMATION MESSAGE 4110 (OUTPX2)
) e+ j5 f; T& \( \& y( R* e
$ N# I6 N9 ^- a" {% t. \5 M
( j# U5 y. L$ B3 g$ x
高级仿真中AUTOPMC  还有BAILOUT改-1也不好用啊   改不过来啊    跪求指点啊