标注3维曲线

ugii

标注3维曲线

1. In Modeling: After Creating a 3 D curve, Moving WCS origin to curve’ End_point1. Drawing a line which length is equal End_point2’s Xc value. Then Using Insert Curves Point SET, Creating N Points ( Equal Arc Length).
+ M) w- J( h- n% X' Q1 ^" L5 M2. In Drafting: Drawing Add View (Adding Front and Top and TFR_TRI View); Expand View; (Using Insert Basic curve line, through Point drawing N Vertical Lines as following Fig.); Insert Dimension( Horizontal and vertical as following Fig.)

So you can clearly represent X,Y,Z of each point.

luoguoan

没什么太大的实际用处

TReversal

Go guy!Thank you for your help,I immediately understand When I have read your information .
But I don't think it isn't useful for us in practicein.